150W LED Power Supply 24V 6.25A For LED Spot and Strip

Feature

TILLUME transformer integrates a switching mode power factor correction (TM PFC) controller and a quasi-resonant controller (QR) controller. PFC controllers provide a cost-effective solution for optimizing power factor.  QR controllers have higher efficiency and lower electromagnetic interference compared to traditional PWM systems,.

TILLUME transformer provides advanced integration and higher performance than conventional  PFC/PWM systems. The built-in TM PFC controller optimizes power conversion efficiency by reducing system costs. The intelligent PFC switch on and off, zero current detection, and frequency limiting mechanisms can achieve better efficiency under any load condition.

LED driver has many built-in green features to optimize power conversion efficiency. 

This LED transformer also integrates multiple protection functions, such as X-CAP discharge, break protection, under voltage lockout, PFC and QR level cycle by cycle current limiting (OCP), PFC and Q R level output over-voltage protection (OVP), PFC and Q R level open loop protection (OLP). Therefore, it can protect the system from damage caused by occasional failures.

Technical Data

Output:

DC Voltage: 24V
Voltage Adjust Range: 23-27.3V
Rated Current: 6.25A
Rated Power: 150W
Ripple& Noise (max.): 150mVp-p
Voltage Tolerance: ±3.0%
Line Regulation: ±0.5%
Load Regulation: ±1.5%
Setup, Rise Time: 500ms, 80ms 115VAC / 230VAC
Hold Up Time（Typ.): 16ms/230VAC 16ms/115VAC

Input:

Voltage Range: 100 ~ 265VAC
Frequency Range: 47 ~ 63Hz
Power Factor: PF≧0.98/115VAC, PF≧0.96/230VAC @Full load
Total Harmonic Distortion: THD< 20%(@load=100%/115VC,230VAC)
Efficiency(Typ.): >90%
AC Current: 0.95A / 115VAC 0.5A / 230VAC
Inrush Current(Typ.): COLD START 60A(twidth=550μs measured at 50% Ipeak) at 230VAC; Per NEMA 410
Leakage Current: <0.25mA / 264VAC
No load power consumption: <0.15W

Protection:

Over Current: 110~ 120%  Rated OCP 5A / Hiccup mode recovers automatically after the fault condition is removed
Short Circuit: Hiccup mode, recovers automatically after the fault condition is removed
Over Voltage: 28 ~ 29.5V Shut down and latch off o/p voltage, re-power on to recover
Over Temperature: Shut down o/p voltage, re-power on to recover

Environment:

Working Temp.: Tcase=-40 ~ +40℃
Max. Case Temp.: Tcase=+85℃
Working Humidity: 20 ~ 95% RH non-condensing
Storage Temp., Humidity: -40 ~ +80℃, 10 ~ 95% RH
Temp. Coefficient: ±0.03%/℃ (0 ~ 50℃)

Safety & EMC:

Safety Standards: EN61347-1, BS EN/EN61347-2-13 independent, EN62384, GB19510.1,GB19510.14,EAC TP TC 004,IP67 approved; Design refer to EN60335-1
Withstand Voltage: I/P-O/P:3.75KVAC
Isolation Resistance: I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH
EMC Emission: Compliance to BS EN/EN55015, BS EN/EN61000-3-2 Class C (@load≧60%) ; BS EN/EN61000-3-3; GB17743 and GB17625.1,EAC TP TC 020
EMC Immunity: Compliance to BS EN/EN61000-4-2,3,4,5,6,8,11; BS EN/EN61547, light industry level (surge immunity Line-Line 2KV); EAC TP TC 020

Others:

Dimension: 226*67*40mm (L*W*H)
Packing: 1.15Kg